Last Activity:05-30-2015 4:17 PM
Likes Given: 2
28 Likes on 21 Posts
Posted in thread: Skip Stewart Prometheus 3 on 05-28-2015 at 02:25 PM
I see a lot of Jon Sharp influence there. Looks like a Nemesis NXT with two wings to me.
Posted in thread: Acroduster Too Pilot Fit on 05-25-2015 at 12:25 AM
Each Acroduster is individually built of course but I would say it is very unlikely that you
would fit. If the yellow one you are referring to is in San Diego, I can say for sure that you
won't fit. I...
Posted in thread: What if there is a biplane flyin and nobody came? on 05-14-2015 at 03:38 AM
Hey Tom - It was great seeing you and meeting Jan at breakfast. Sorry the weather sucked like
it did but glad we ran into each other.
Posted in thread: Twisted Composites Props is retired from making props on 05-09-2015 at 05:10 AM
Twisted Composites has ruled Formula One Air Racing at Reno for years but that is a very small
market. He makes a (Great) prop and it probably gets passed on to 4 or 5 owners before it
finally gets re...
Posted in thread: Stick Boots on 05-07-2015 at 02:18 PM
If you can't find one, you make a paper pattern and ask your friendly parachute rigger to make
Posted in thread: Rotec TBI installation on 04-30-2015 at 04:38 AM
Unless they are in close proximity to a heat source - such as an exhaust - I wouldn't be too
concerned about fire sleeving that short run. Those fittings with that 180 degree turn though,
do raise con...
Posted in thread: Rotec TBI installation on 04-29-2015 at 05:51 PM
>Still trying to figure out this surging idle. Haven't heard back from Rotec. Does anyone have
any insight on this issue? I would search for any signs of the fuel being _preheated_ prior to
Posted in thread: Have you purchased a canopy lately? on 04-06-2015 at 09:43 PM
Thanks for the response, I found the answer to my question and a buyer already. It's one of
Todd's - full length to cover both holes.
Posted in thread: Have you purchased a canopy lately? on 04-05-2015 at 12:21 AM
I have a brand new canopy for a Starduster that I took in trade and am wondering what I should
sell it for. Any idea what a brand new canopy cost these days? Thanks.
Posted in thread: Instrument panel construction... ? on 04-03-2015 at 04:34 PM
Here's how I did mine... Riveted tabs on the upper curve which attach to the top fuselage skin,
and 3 welded tabs on the Fuse to hold the bottom in place. I used a good punch and lots of oil
to cut al...