• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Center block
Jerry

Center block

A good way to make sure that you position your jigging blocks so that the tubing will fall on the center line is to make up this simple center block. Cut a piece of wood the width of your tubing. Draw a center line on both the front and rear of it. Line the lines up front and back, place your jig blocks on either side and screw in. Fast and accurate.
There are no comments to display.

Media information

Album
The Tailfeathers
Added by
Jerry
Date added
View count
886
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top