• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Lower Rear Wing Fitting Drawing
Jerry

Lower Rear Wing Fitting Drawing

The second of many steps in making a fitting. After I drew out the fitting on DeltaCAD (the first step) I printed it out and glued it onto the sheet of .100. Next I'll need to rough cut it out, then file and sand the edges smooth where I'll be making the bends. Edges that will be welded don't need to be sandpaper smooth, filing then down is all you need to do.
There are no comments to display.

Media information

Album
The Fuselage
Added by
Jerry
Date added
View count
807
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top