Quantcast
Rudder ready for tack welding
J

Rudder ready for tack welding

It took most of an afternoon to bend the 3/8" tubing to make the trailing edge of the rudder with a conduit bender. I am looking forward to bending the leading edge of the horizontal stabilizer. We discovered it is possible to heat the 7/8" rudder post to a dull red using mapp gas. Hot enough to flatten the end as needed.
There are no comments to display.

Media information

Category
General Biplane Photos
Album
Tail section
Added by
JimW
Date added
View count
418
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Top