• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Annealing aluminum with rivets... the good, the bad, or the ugly?

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jerry

Radial Skybolt Builder: 220.45% completed
*
Joined
Aug 21, 2006
Messages
4,749
Reaction score
697
Location
South Jersey
Just finished up both of my seat backs. They're made out of 6061 T6... two pieces held together with a lot of 3/32 rivets.

Question: Can I anneal this without affecting the rivets?
 

Latest posts

Back
Top