- Joined
- Jan 23, 2018
- Messages
- 46
- Reaction score
- 3
Hey Guys and Gals! I’ve got my Acroduster 2 rigged so if flys so much better now thanks to some of our members advice and support. My challenge now is dealing with my center section being lower on the right side than the left. It’s 1/2 inch lower in front and 3/4 “ lower in back than left side.
Looking for standard measurements that I can use to rig it properly. Also proper procedures for supporting the upper and lower wings during adjustments. Do I have to disconnect both top wings to adjust center section. Gas lines?
As it is now I’m flying with the upper wing at approximately 1.5 -2. degree dihedral and it should be zero.
Thanks
Looking for standard measurements that I can use to rig it properly. Also proper procedures for supporting the upper and lower wings during adjustments. Do I have to disconnect both top wings to adjust center section. Gas lines?
As it is now I’m flying with the upper wing at approximately 1.5 -2. degree dihedral and it should be zero.
Thanks