• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Drag wire nuts

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

ccoffin

Well-Known Member
*
Joined
Nov 30, 2013
Messages
63
Reaction score
7
Drilling/installing my first set of drag wires in the upper wing on the Skybolt. Built a basic jig from pictures of others on this site and the first set of holes was perfect. I was going to use standard AN365 locknut with .100 4130 square washers on the front spars and double nut at the rear spar and tighten from the rear. Planning to use plywood leading edges with no access to the front nuts and then put access rings to adjust the drag wires at the rear spar. Is this a typical approach or is there a reason to have access to both front and rear nuts?
 

Latest posts

Back
Top