• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Elevator horn

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Kelvin Rempel

Registered Users
Supporting Member
Joined
Jan 11, 2009
Messages
987
Reaction score
901
Location
Ontario Canada
Stupid question of the evening. The elevator horn was predrilled and reamed by the factory. The 2 out holes line up nicely in both horns but the middle hole was not drilled straight so I can’t get an AN3 bolt through the 2 assembly’s in that hole. What’s the best fix? If I file the hole out it will be elongated on one side? I’m thinking get it welded closed and drill a new hole?
 

Attachments

  • 8B28C45A-BC68-4D0D-AA45-AFAAF6710C97.jpeg
    8B28C45A-BC68-4D0D-AA45-AFAAF6710C97.jpeg
    39.9 KB · Views: 90

Latest posts

Back
Top