I finished installing firesleeve and a new ignition harness last weekend.
Firesleeve was the aerospace spec'd sleeve sold through McMaster. Ends were sealed using High Temp orange silicone. Sleeving was attached to the hoses using .041" safety wire via the Clamp-Tite tool. (the clamp is located over the hose fittings on the hose assembly, not over the hose itself).
http://www.youtube.com/watch?feature=player_embedded&v=Zb1U6aaTozI
The Ignition Harness is from Kelly Aerospace.
Firesleeve was the aerospace spec'd sleeve sold through McMaster. Ends were sealed using High Temp orange silicone. Sleeving was attached to the hoses using .041" safety wire via the Clamp-Tite tool. (the clamp is located over the hose fittings on the hose assembly, not over the hose itself).
http://www.youtube.com/watch?feature=player_embedded&v=Zb1U6aaTozI
The Ignition Harness is from Kelly Aerospace.
Last edited: