• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Hinge bearing fit?

shop deals on amazon
Advertise with us
Shop deals on ebay
Beej

Beej

Creator of this place
Staff member
Administrator
Moderator
Joined
Jan 1, 2006
Messages
6,596
Reaction score
1,706
Location
Austin, TX
At this rate wer'e gonna end up starting a new sub forum just for the aileron setup :0| ;-)


There are 4 brackets which the slave brackets attach to, these 4 don't have internal bushings. This means that the rod end bearing sits in the middle of the bracket with space either side? Do I needto make bushings [spacers] to fill this gap?






20070504_233431_Dscf0022.jpg
 
You must log in or register to reply here.

Similar threads

Mike_H
Pitts S1-S Slave Strut Cut Out
Replies
3
Views
3K
Pitts S-1E
Pitts S-1E
brooksmershon
Pitts S-1S engine removed
Replies
12
Views
2K
smizo
smizo
rbilu
S1-11-b Slave Strut Question
Replies
3
Views
379
garyg
G
R
Cowling repair / replace
2 3 4
Replies
76
Views
4K
Larry Lyons
Larry Lyons
Ralsmark
Bungee Tool DeLuxe
Replies
18
Views
2K
Ralsmark
Ralsmark

Latest posts

Top