I know I am a long way from purchase of radio's
But I have been looking at the small 2 1/4" units.
The problem I see is, I only have 7 1/2 inches depth for installation.
A quick search shows me that the Becker is too long at slightly over 8" and the Flightline could be ok at 6 1/4"
What I would like to do is cut the holes for 2 1/4" round radio and transponder, that way I can finish and paint the instrument panel.
The intercom will probably be set in the lower center compartment.
Anyone had experience with installing these 2 1/4inchers in tight areas?
And if so, which one was used?
Cheers.
A picture to show where I am considering placing them.
But I have been looking at the small 2 1/4" units.
The problem I see is, I only have 7 1/2 inches depth for installation.
A quick search shows me that the Becker is too long at slightly over 8" and the Flightline could be ok at 6 1/4"
What I would like to do is cut the holes for 2 1/4" round radio and transponder, that way I can finish and paint the instrument panel.
The intercom will probably be set in the lower center compartment.
Anyone had experience with installing these 2 1/4inchers in tight areas?
And if so, which one was used?
Cheers.
A picture to show where I am considering placing them.
