I'm drawing out the Upper Front Spar Plate, Upper Rear Spar Plate and Lower Front Spar Plate Fittings. (Page 14 Revised Dated 3-90)
The drawing shows the large center hole onthe Upper and LowerFront Spar Plates as7/8". The center hole for the Upper Rear as 5/16".
What are the sizes of the other four holes on all three plates ? 1/4" ?
And what thickness is the material ? .125 (4130) ? as it shows for the old style fitttings on page 6 ?
Good or bad assumption ?
Oh... and another thing. What are the hole locations for the 7/8" holes for the Upper and Lower Front Spar Plates ? It just has Sta 76 and Sta 97 3/4.
thanksEdited by: Jerry
The drawing shows the large center hole onthe Upper and LowerFront Spar Plates as7/8". The center hole for the Upper Rear as 5/16".
What are the sizes of the other four holes on all three plates ? 1/4" ?
And what thickness is the material ? .125 (4130) ? as it shows for the old style fitttings on page 6 ?
Good or bad assumption ?
Oh... and another thing. What are the hole locations for the 7/8" holes for the Upper and Lower Front Spar Plates ? It just has Sta 76 and Sta 97 3/4.
thanksEdited by: Jerry