- Joined
- Jan 3, 2007
- Messages
- 1,329
- Reaction score
- 570
This is for Jerry. Couldn't get them to load in a PM
Engine mount looks something like this. Drawing is just a sketch..no scale. There is also a horizontal bushing at the lower diagonal intersection for a total of 5 mounting positions at the firewall.
There are steel straps welded to the main legs..around the mount ring and again to the backside of each main leg. Much like a wing stut bushing.
ring is 1.25 OD
main legs are 1.00 OD
support diagonals are .875 OD
I believe all legs/diagonals are .049 wall.
Spool bushing is 3/8 ID and 5/8 OD
Spool base is 1.75 OD
What else???
Edited by: bigblackmastiff
Engine mount looks something like this. Drawing is just a sketch..no scale. There is also a horizontal bushing at the lower diagonal intersection for a total of 5 mounting positions at the firewall.
There are steel straps welded to the main legs..around the mount ring and again to the backside of each main leg. Much like a wing stut bushing.
ring is 1.25 OD
main legs are 1.00 OD
support diagonals are .875 OD
I believe all legs/diagonals are .049 wall.
Spool bushing is 3/8 ID and 5/8 OD
Spool base is 1.75 OD
What else???