- Joined
- Apr 17, 2012
- Messages
- 498
- Reaction score
- 219
I need some blisters to go on the aluminum sheet covers over the Jodel landing gear attach. The bolt heads stick up above the surface of the wing about 1/2 inch. I wanted to form them into the covers, but realized that they are too close together to be able to do that with the tooling I built. So I tried forming just a single blister that I could rivet onto the covers. Didn't go so well...
I could try forming it half way then annealing, but I'm not sure I'm in the mood for that much education. Does anyone know of a source for stock blisters about 1 3/4 x 3 x 5/8 inch high?
Warren
I could try forming it half way then annealing, but I'm not sure I'm in the mood for that much education. Does anyone know of a source for stock blisters about 1 3/4 x 3 x 5/8 inch high?
Warren