I have an 0-235 C1 or 2C. Can I remove the prop bushings and move them from the inner set of holes to the outer set of holes on the flange to fit another prop? Lycoming shows two flanges and calls them type 1 and type 2, but both have the same thickness, same holes, and same O.D. just the bushing location is different. I just acquired a prop off a Pitts with an 0-235 but the bolt pattern is different. Both sets of holes are present on both prop flanges. I have requested membership in the Yahoo Lycoming chat group but have not been accepted so just throwing this out here.
L
L
