I'm about to start wings. I have finished ailerons. I'll probably get spar
material from Wicks since I won't have to pay shipping . My question has
do with the wing ribs. I've had them done for a long time but this is the
last opportunity for me to change shape of the nose piece to allow for
the use of plywood leading edges. Is the consensus of opinion that I
should change shape now or make up the difference after wing is built.
Also if I'm not sure which engine (not a radial) should I just go ahead
and use Douglas Fir for the extra strength.
Thanks in advance
material from Wicks since I won't have to pay shipping . My question has
do with the wing ribs. I've had them done for a long time but this is the
last opportunity for me to change shape of the nose piece to allow for
the use of plywood leading edges. Is the consensus of opinion that I
should change shape now or make up the difference after wing is built.
Also if I'm not sure which engine (not a radial) should I just go ahead
and use Douglas Fir for the extra strength.
Thanks in advance