• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Skybolt upper wing rib spar bays

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

russ_homans

Registered Users
Supporting Member
Joined
Sep 24, 2013
Messages
33
Reaction score
9
I am starting to build my upper wing rib jig along with cutting all pieces. I am probably over thinking the process but given the fact that the upper wings are swept back 6.5-degrees does this mean the vertical pieces where the spars pass through have to be bevel cut the corresponding 6.5-degrees?
Thanks
 

Latest posts

Back
Top