• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Slight Warping on Mass Balance Cover Plates

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jerry

Radial Skybolt Builder: 220.45% completed
*
Joined
Aug 21, 2006
Messages
4,749
Reaction score
697
Location
South Jersey
Just finished welding in the rods to hold the lead for mass balancing the elevators. In doing so... the plates, top and bottom, are slightly warped.


Question: What would you use to make these plates appear straight again ? Micro balloon fill ? (actually I'm not even sure if something like that could work)


Also, will the liquidfied lead warp these any further ?
 

Latest posts

Back
Top