• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Stick Boot welding question

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

MarkRadio

Well-Known Member
Joined
Aug 8, 2007
Messages
145
Reaction score
2
It seems I can't buy stick boots so here goes. I tried bending .063 4130 fl
as called out in plans, not successful. I was going to try .050 as Al Rice did. The question is, can I use 18ga., .050 weld steel from Lowe's or does it have to be 4130. the difference is about 60 miles.

.
Thanks,
Mark
 

Latest posts

Back
Top