• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Trim, Servo, or Balance Tab?

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Neil

Well-Known Member
Lifetime Supporter
Joined
Nov 10, 2006
Messages
6,640
Reaction score
1,216
Location
Monroe, Louisiana


I've noticed some confusion here on just what sort of tab is on a particular airplane so I thought I would at least explain how the difference was explained to me.

Trim Tab; The simplest of all, a small tab screwed, riveted or welded to the trailing edge of a control surface that can be bent to correct for heaviness or correct cruse flight trim.

Cockpit controlled Trim Tab; A hinged variant of the Trim Tab that is attached with a linkage of some sort that allows the pilot to set the tab to a specific point in flight.

Balance Tab; A hinged tab that is linked in such a way that it moves in the opposite direction of the control surface to reduce or "Balance" the control forces. Usually ground adjustable.

Balance/Trim Tab; Used with a cockpit controlled device that allows the pilot to trim the airplane in addition to providing reduced control forces.


Servo Tab; A tab that is rigged into the control system in such a way that the initial movement of the control only moves the Tab and the Tab drives the control surface through a specified range requiring very little force on the control input. The linkage provides that larger control inputs move the control surface.

Anti Servo Tab; Used on stabilators (Piper) to return the control surface to neutral as I understand them but I am least familiar with how these work.

Any one with a more technical explanation is welcome to comment.




Edited by: Neil
 

Latest posts

Back
Top