• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Upper Wing VII

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Beej

Creator of this place
Staff member
Administrator
Moderator
Joined
Jan 1, 2006
Messages
6,652
Reaction score
1,886
Location
Austin, TX





<TD vAlign=top>New metal cutting bandsaw from Harbor Freight...The upper wing saga continues. It seems never-ending. Both wings have been tramelled for a while now with their new drag blocks - all is OK.


The tip bow was finish sanded and looks nice. TIP: On the plans, the tip bow profile shows a radius with a kind of french curve look, I replicated this with a lot of hard work, there really is no point - just use a regular round-overrouter bit set up in a shaper [or in my case, a router bolted inverted to a box with a hole in it].


Both wings were taken outside, flipped over, and set back in the spar benchjigs on opposite sides of the bench, ie the left wing is now bottom-up, but sits on the right side of the bench. The good news is, both wings slotted perfectly into the opposing jigs..'means I have some consistancy somewhere! The left aileron well is now complete with 1/32 ply forming the radius in the well.Spar filler strips [with a 1/8 gap each side of each strip to allow for drainage] were then fitted.I removed the spar bench jigs so I had clearance for clearcoating. Iclearcoated the left wing under-side [now facing up]to completion [2 coats]. It was then turned overso I couldapplyclearcoat to the areas I couldn't get to previously.


I am fitting the old type external flying wire brackets because I have SS wires to match that format already. I made a mess of 3 of my brackets which I had acquired in a trade, so I decided to finally go buy myself a metal cutting bandsaw and do some steel cutting. The brackets have now been cut and match drilled. I usually get fittings powder coated, but i want these brackets on now, so I am going to primer them instead today so I can put them to bed tomorrow.


To do: right wing -aileron well, finish sand tip bow,clearcoat.


then


Fit LE ply to both wings, feather-in the foam tips to the LE ply with Superfil,finallysplice the two wings together, fit center section bottom ply, clearcoat,then hang on the wall..phew.








Ply aileron hinge wells...

My first steel work!...
 

Latest posts

Back
Top