• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Walking Beam

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

scottly

Well-Known Member
*
Joined
Sep 13, 2006
Messages
1,639
Reaction score
4
I decided to construct my walking beam to the plans dimension. The plans walking beam does not allow for removal without cutting the fabric. So, the question is this: Why would you ever want to remove it? Lubrication is what comes to mind...



Now, the other designs wih bearings are nice setups...I thought about that. But, one thing I see when I look at the other bearing designs is a set of "ears" welded to a fuse cross member, with the walking beam bolted between the ears. Although this bearing setup might be smoother, it is wortht he extra weight? Maybe....but for the average builder, what about the added complexity of building this setup? I decided to keep it simple. Now, I might change my mind and build a bearing-type later, but for now, I decided that the installation of a simple grease fitting would solve the problem of lubrication, negating the need to ever disassemble.


Although you could just as easily braze a nut on to the cross member tube, I decided to go for the same type I am using on my rudder pedals. I made a threaded fitting from some 5/16 4130 tubing. I drilled and tapped it to accomodate 6mm zirk fitting, which seem to be most common in auto parts stores. I then notched one end to mate with the round tube I was mounting it on...


20071028_185215_walking_beam.jpg





To keep the heat signature small, I used a 1/16" tungsten/collet setup, a .035 wire, and set the machine to 35 amps. It produces less of a heat signature than brazing.


Below is my finished part....like the plans, but greasable.


20071028_185425_walking_beam1.jpg


 

Latest posts

Back
Top