• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $29.95/year to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).

WTB Sensenich 74" Prop

marquartflyer

Registered Users
Lifetime Supporter
Joined
Dec 20, 2010
Messages
212
Reaction score
132
Location
Daytona Beach FL
A Marquart buddy is looking for a 74" diameter Sensenich metal prop 58-60" pitch ,-1/2" bolt holes for IO-320.
 

pittss1flyer

Well-Known Member
Supporting Member
Joined
Nov 13, 2007
Messages
156
Reaction score
39
I could be wrong, but I believe that O/IO 320s use either 3/8" or 7/16" prop bolts. The O/IO 360s use 1/2". Perhaps yours is different. I have a Sensenich prop which does have 1/2" holes for prop bolts that came off of a IO-360. I think it will meet your size and pitch, but I need to get back to my hangar to check it
 

Neil

Well-Known Member
Lifetime Supporter
Joined
Nov 10, 2006
Messages
6,602
Reaction score
1,163
Location
Monroe, Louisiana
I could be wrong, but I believe that O/IO 320s use either 3/8" or 7/16" prop bolts. The O/IO 360s use 1/2". Perhaps yours is different. I have a Sensenich prop which does have 1/2" holes for prop bolts that came off of a IO-360. I think it will meet your size and pitch, but I need to get back to my hangar to check it
Correct on the 3/8" or 7/16" prop bolts on the 320s.
 

EAABipe40FF

Registered Users
Supporting Member
Joined
May 30, 2009
Messages
6,927
Reaction score
1,548
Location
Springfield, WV
My IO320B1A had 7/16"/CS. I installed a Sen. 74DM6-58(3/8") with new 3/8" bushings.

Jack
 

marquartflyer

Registered Users
Lifetime Supporter
Joined
Dec 20, 2010
Messages
212
Reaction score
132
Location
Daytona Beach FL
Thanks for the heads up. I'll double check with my buddy. - The 320 was built from boneyard so who knows.
 

Latest posts

Top