I need to match-drill a few 1/2" holes thru my center section spars (see photo).
Is there a way to do it without a drill block?
thanks
Jerry
Is there a way to do it without a drill block?
thanks
Jerry
-
Become a Subscribing Member today!
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web.
Why become a Subscribing Member?
- In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
- We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).
- Annual membership also comes with two BiplaneForum.com decals.
Become a Subscribing Member and access the Biplane Forum in full!
Is there an easy way to match-drill 1/2" hole thru a spar?
- Thread starter Jerry
- Start date
Dennis5678
Registered Users
- Joined
- Jan 5, 2016
- Messages
- 658
- Reaction score
- 76
- Joined
- May 18, 2012
- Messages
- 4,260
- Reaction score
- 947
segelkunstflug
Registered Users
- Joined
- Sep 4, 2015
- Messages
- 15
- Reaction score
- 6
Last edited:
Last edited:
