The formers for the sheet metal on the forward fuselage are not in the plans location. The aft two wind up 28 inches apart vs the 22.5 in the plans. Is this too far apart? The aircraft will have a 540 so I am worried about drumming.
-
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.
Fuselage Sheet Metal Stand-off spacing
- Thread starter Robin Tripp
- Start date
- Joined
- Nov 24, 2007
- Messages
- 3,729
- Reaction score
- 1,011
Last edited:
