• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.



Grind weld under forward landing gear fitting ?

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jerry

Radial Skybolt Builder: 220.45% completed
*
Joined
Aug 21, 2006
Messages
4,751
Reaction score
699
Location
South Jersey
I'm ready to weld the fittings on the fuselage. The front landing gear fitting sits right over the bungee truss. The welds for the truss, at the very bottom, are a little bit higher than the longeron itself.


Is it OK to grind down this weld a little so that I have the fitting on a flat surface ? I would think so.
 

Latest posts

Back
Top