Any suggestions on how best to route a throttle and mixture cables from the firewall to the rear mounted fuel servo of my IO-540 engine? The center fuel tank makes it difficult to route around without sharp bends that could cause potential binding of the cables. I would like to avoidthe costly conversion to a front mounted fuel servo.
-
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.
Throttle Cable Routing
- Thread starter 4deuces
- Start date
