I'm getting close to completing my wings and have a question for those who have traveled this path.
I have the internal flying wire hardware.
What have you done to gain access for installation and adjustment of the flying and landing wires to the retaining pin?
(also, I am sure that I will need to tighten the 4 bolts of the aluminum plates, after the wire to retaining pin is aligned, after rigging)
When the ply leading edge is installed. When the fabric is completed it is too late, so something has to be constructed prior to covering.
I am thinking access panels that can be removed. Maybe a spruce frame within the rib bay, that I can screw on an access panel after the paint?
Any photographs would be appreciated.
A couple of pictures below to show what I am talking about.
(this is a lower wing that is upside down)
I have the internal flying wire hardware.
What have you done to gain access for installation and adjustment of the flying and landing wires to the retaining pin?
(also, I am sure that I will need to tighten the 4 bolts of the aluminum plates, after the wire to retaining pin is aligned, after rigging)
When the ply leading edge is installed. When the fabric is completed it is too late, so something has to be constructed prior to covering.
I am thinking access panels that can be removed. Maybe a spruce frame within the rib bay, that I can screw on an access panel after the paint?
Any photographs would be appreciated.
A couple of pictures below to show what I am talking about.
(this is a lower wing that is upside down)