Looking at the option of installing bolt on axles to facilitate toe-in/ out alignment adjustments.
I believe this has already been done on a couple of Skyotes'.
Specifically looking for flange / mounting plate ideas, Presumably I will be using grove axles.
My landing gear is now complete in accordance with original design, however approximately 3/8 inch toe in needs to be adjusted out. Seems like too much to fix with a heat wrench and a pipe.
thanks tom
I believe this has already been done on a couple of Skyotes'.
Specifically looking for flange / mounting plate ideas, Presumably I will be using grove axles.
My landing gear is now complete in accordance with original design, however approximately 3/8 inch toe in needs to be adjusted out. Seems like too much to fix with a heat wrench and a pipe.
thanks tom