- Joined
- Apr 17, 2012
- Messages
- 503
- Reaction score
- 221
Finally, after about 25 years, I actually did something to the Acro Sport besides move the box around. Naturally, I immediately ran into something that puzzles me.
The butt ribs on the center section have grooves cut into the bottom capstrip to accommodate the front attach fittings. Is that normal? I don't see anything about it on the drawing, but those aren't highly detailed drawings anyway.
In the process of looking through past threads to see if I could find an answer to this, I was disappointed to find that I couldn't see the pictures in Smizo's build thread (part 1 - didn't check the others). Is that just something I'm doing wrong? I don't have the same goals, skills, or tooling he does, but I was still counting on getting a lot of useful information from those threads.
Warren
The butt ribs on the center section have grooves cut into the bottom capstrip to accommodate the front attach fittings. Is that normal? I don't see anything about it on the drawing, but those aren't highly detailed drawings anyway.
In the process of looking through past threads to see if I could find an answer to this, I was disappointed to find that I couldn't see the pictures in Smizo's build thread (part 1 - didn't check the others). Is that just something I'm doing wrong? I don't have the same goals, skills, or tooling he does, but I was still counting on getting a lot of useful information from those threads.
Warren
