Flying High
Well-Known Member
- Joined
- Aug 28, 2009
- Messages
- 612
- Reaction score
- 59
I was reading through the overhaul manual for my angle valve IO-360 and read this;
Angle Valve Cylinder. Slide rocker shaft back
and install rocker (22, figure 6-6) and thrust washer
(23, figure 6-6). Before installing exhaust valve rocker
place special cap (32, figure 6-6) over the exhaust
valve stem. Slide rocker shaft back into position.
Why does the exhaust valve have a "special" cap?
Angle Valve Cylinder. Slide rocker shaft back
and install rocker (22, figure 6-6) and thrust washer
(23, figure 6-6). Before installing exhaust valve rocker
place special cap (32, figure 6-6) over the exhaust
valve stem. Slide rocker shaft back into position.
Why does the exhaust valve have a "special" cap?
