• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $29.95/year to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).

  • If you have bought, sold or gained information from our Classifieds, please donate to Biplane Forum and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Panel Hole Cutter and Cleveland Master Cyls.

mjk51

Member
Joined
Sep 2, 2006
Messages
172
Reaction score
53
Location
Fostoria, Ohio
Dont think I'll be needing these again:

Instrument Panel Knock-out. From Aircraft Spruce. Very good shape. Cut out about 15 holes with it. Asking $95. I'll pay shipping to USA.
0031small.JPG

020small.JPG
Two Cleveland Master Brake Cylinders. Model 10-54a. These were manufactured in June of 2014. I purchased them new. I mounted them on my Skybolt but changed them out for a pair of 10-30's. They have not seen brake fluid yet. Also there is a pair of threaded adapters I turned out. Askking $515. I'll pay shipping to USA.
[/ATTACH]
Here's some specs. on the cylinders...Spring-loaded piston type assembly without reservoir. Pin center length 7.88". Bore 5/8". Stroke 1.62". Wt. .45 oz. Ports in-line, no fittings
 

Attachments

Last edited:

Larry Lyons

Registered Users
Lifetime Supporter
Joined
Oct 1, 2012
Messages
4,791
Reaction score
1,291
Location
NW Illinois
Go for it Gary, i don't need it but would have if no one showed interest in it.
 

garyg

Well-Known Member
Lifetime Supporter
Joined
Nov 3, 2011
Messages
839
Reaction score
193
Go for it Gary, i don't need it but would have if no one showed interest in it.
Larry,

Ok,

I won't need it for much. I think I only have 4 holes to cut since we are going to install a MGL Discovery-Lite. So soon after that, it may become available again.



PM sent......

gjg
 

Larry Lyons

Registered Users
Lifetime Supporter
Joined
Oct 1, 2012
Messages
4,791
Reaction score
1,291
Location
NW Illinois
This is just one of those things that hoarders like me will buy and keep just because I or someone I know might need it someday. I have many many tools like that and cherish each and everyone. Especially when on that odd occasion, I need to use one of them.
 

race38

Member
Lifetime Supporter
Joined
Apr 20, 2012
Messages
1,862
Reaction score
764
Location
Owings, MD
Put me on the list with you Larry! I'll take it when Beej is done with it.
 

EAABipe40FF

Registered Users
Supporting Member
Joined
May 30, 2009
Messages
6,872
Reaction score
1,525
Location
Springfield, WV
I was almost ready to go for it myself but only have one or two holes so I'll nibble and file.:)

Jack
 

Latest posts

Top