We picked up an S1-D project and noticed the wingseasiest were built like the S1-11 with both spars on the lower the same at the root. They don't line up with the attach points on the fuselage. Can we just cut off the rear fittings and fabricate new longer ones so the bolt holes line up? They are about a half inch out. I'll try to get a few pictures so it makes sense a little more. Just gotta get my s1-11 wings out of the way first.
-
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.
S1-D wings.
- Thread starter flyapitts
- Start date
