I'm planning to remove the smoke system from my S-2A and I want to cap the fittings instead of removing them and patching the hole. So,,,,,,,,,
Is there an AN929 cap in stainless that can be bought? I found B-nuts and I can machine the flared cap but I'd rather buy two from a vendor than make them. Or maybe just welding a disk on the end of the B-nut would work??
Is there an AN929 cap in stainless that can be bought? I found B-nuts and I can machine the flared cap but I'd rather buy two from a vendor than make them. Or maybe just welding a disk on the end of the B-nut would work??
Last edited: