Here is a simple enough question thatis currentlybugging me. If you were going toweld nuts to 4130 tube to insert grease fittings, what material nuts would you use? Would cad-plated AN nuts work?Something else? Do you need to scuff off any plating?
-
The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.
The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.
installing grease fittings
- Thread starter JimW
- Start date
- Joined
- Jan 16, 2007
- Messages
- 556
- Reaction score
- 108
- Joined
- Jan 3, 2007
- Messages
- 1,332
- Reaction score
- 577
- Joined
- Sep 7, 2009
- Messages
- 7,612
- Reaction score
- 5,770
Tcraft
Registered Users
Last edited:
