My elevator trim tab connectors are made up of 1/4 OD tube, with forked ends mated to the tubewith what I 'think' is silver soldering. These forked ends are on both pushrods, therefore I have no fine adjustment if I need it. I want some adjustment..what hardware/approach do I need for this?
I thought about just changing one side, by replacing the 1/4 tube with a solid 1/4" rod as per plans, then threading the end to accept anAN486 fork rod end, but this forked endlooks 'bulky'? Any other ideas? Or is the AN486 the way to go?
http://www.aircraftspruce.com/catalog/appages/an486.php