New posts

The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction). Annual membership also comes with two BiplaneForum.com decals.

Click here to register and become a Subscribing Member

Wing Rigging-Drilling Spar

Thread starter user 38
Start date Nov 11, 2012

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

user 38

Well-Known Member

Nov 11, 2012

Gents,

In my plans, I see two incidental references to drilling through the spar plate such that the row of the 3 holes (top row on Plates) should be aligned with the centerline of the spar. But, I cannot find a specific reference to this in the plans. Can does anyone know where I can find a specific reference in the plans to aligning the 3 spar plate holes with the center line of the spar?
Thanks in advance

Dave

You must log in or register to reply here.