SIne I haven't gotten to the point of building my fuse, nor have I looked into it, I have a question that may seem silly to some.
I just built my rudder pedals...should I powercoat them before I install them, or wait until I have the entire fuse ready and the pedals will just get done after they are installed?
Also, should I install a grease fitting on the pedal shafts for smooth operation? Where else will I need to put grease fittings?
I just built my rudder pedals...should I powercoat them before I install them, or wait until I have the entire fuse ready and the pedals will just get done after they are installed?
Also, should I install a grease fitting on the pedal shafts for smooth operation? Where else will I need to put grease fittings?