For my Skybolt;
My new replacement cylinders arrived and are installed.
These are the ones that have the access for the injectors. (the old ones didn't)
I have installed the flow divider and the nozzles and now I need to bend tube (the fuel lines).
The lines between the divider and nozzles need to be formed and fitted.
Questions:
-Are there any photo's out there of existing set ups that can help me?
-Is there anything special to bend the tubes with? or do I use bare strength.
I would hate to kink the tube at the bend!
-Do I need to purchase a turbine flow meter transducer?
What is the benefit of a flow meter? (apart from letting me know how much gas I am consuming)
If there are tips on this install that can help out = greatly appreciated.
A couple of photo's to show what I have so far.
Thanks.
My new replacement cylinders arrived and are installed.
These are the ones that have the access for the injectors. (the old ones didn't)
I have installed the flow divider and the nozzles and now I need to bend tube (the fuel lines).
The lines between the divider and nozzles need to be formed and fitted.
Questions:
-Are there any photo's out there of existing set ups that can help me?
-Is there anything special to bend the tubes with? or do I use bare strength.
I would hate to kink the tube at the bend!
-Do I need to purchase a turbine flow meter transducer?
What is the benefit of a flow meter? (apart from letting me know how much gas I am consuming)
If there are tips on this install that can help out = greatly appreciated.
A couple of photo's to show what I have so far.
Thanks.