• The Biplane Forum is a large global active community of biplane builders, owners and pilots. From Pitts to Skybolts, to older barnstormers, all types are welcome. In addition to our active community, our content boasts exhaustive technical information which is often sought after for projects and maintenance. This information has accumulated over the 12+ years the forum has been in existence.

    The Biplane Forum is a private community. Subscriptions are only $49.99/year or $6.99/month to gain access to this great community and unmatched source of information not found anywhere else on the web. We are also a great resource for non biplane users, since many GA aircraft are built the same way (fabric and tube construction).

Pitts S-1-11B DWGs or .DXFs out there?

Flybipe

Well-Known Member
Lifetime Supporter
Joined
Aug 19, 2007
Messages
471
Reaction score
289
Before I spend a lot of time programming all the flat stock steel parts for burning, does anyone already have these parts in .dwg or .dxf format that they would mind sharing?


Not a lot of Super Stinkers have been built, but thought perhaps someone has already done this programming vs. cutting all the steel fittings by hand.


Thanks!


JoshEdited by: Flybipe
 

Latest posts

Top